Mackie 1640 User Manual download pdf (Page 34)

ONYX 1640

Rack Mounting the Onyx 1640

The Rack Ear brackets supplied with the Onyx 1640 allow

the mixer to be mounted in a standard 19" rack.

The mixer will take up 14 rack spaces in its normal Pod po-

sition, and you should allow an extra 1 or 2 rack spaces above

to make your connections. (If you have rear-mounted the Pod,

the mixer will take up 12 rack spaces.)

The mixer comes with a left and a right rack ear bracket,

and a little plastic bag containing six countersunk screws

(longer than the original screws).

Tools Required:

One Phillips screwdriver.

Procedure:

1. Turn off the mixer, and disconnect the power cord, and all

connecting cords.

2. Place the mixer face up on a soft and dry ﬂ at surface.

3. Remove the six screws as shown below, and keep them in

a safe place for further use. Do not remove all the screws

on each side, as two remain in place as shown. If you are

not planning on using the old screws again, take them

down to your local recycling plant. They may give you

some money just to go away.

4. Using only the new screws supplied, secure the rack ear

brackets to each side of the mixer as shown. Hand-tighten

the screws securely. The brackets are marked left and

right, so make sure they go on the correct side.

5. Offer up the mixer to your rack and secure it in place

with eight rack screws (not supplied). Remember to leave

enough room at the top so you can easily make your con-

nections.

6. That's about it really. Take the rest of the day off — you

have done well.

Left

Bracket

Right

Bracket

1 2 ... 29 30 31 32 33 34 35 36

No comments

Mackie 1640 User Manual Page 34